This section describes how to set up a non-producing node within the EOSIO network. A non-producing node is a node that is not configured to produce blocks, instead it is connected and synchronized with other peers from an
EOSIO based blockchain, exposing one or more services publicly or privately by enabling one or more Nodeos Plugins, except the
- Install the EOSIO software before starting this section.
- It is assumed that
keosdare accessible through the path. If you built EOSIO using shell scripts, make sure to run the Install Script.
- Know how to pass Nodeos options to enable or disable functionality.
To setup a non-producing node is simple.
You need to set some peers in your config ini, for example:
# config.ini: p2p-peer-address = 184.108.40.206:9876
Or you can include the peer in as a boot flag when running
nodeos, as follows:
nodeos ... --p2p-peer-address=220.127.116.11:9876
Each available plugin is listed and detailed in the Nodeos Plugins section. When
nodeos starts, it will expose the functionality provided by the enabled plugins it was started with. For example, if you start
state_history_plugin enabled, you will have a non-producing node that offers full blockchain history. If you start
http_plugin enabled, you will have a non-producing node which exposes the EOSIO RPC API. Therefore, you can extend the basic functionality provided by a non-producing node by enabling any number of existing plugins on top of it. Another aspect to consider is that some plugins have dependencies to other plugins. Therefore, you need to satisfy all dependencies for a plugin in order to enable it.